IMIS | Lifewatch regional portal

You are here

IMIS

[ report an error in this record ]basket (0): add | show Print this page

Wave overtopping at near-vertical seawalls: Influence of foreshore evolution during storms
Briganti, R.; Musumeci, R.E.; Van der Meer, J.; Romano, A.; Stancanelli, Laura Maria; Kudella, M.; Akbar, R.; Mukhdiar, R.; Altomare, C.; Suzuki, T.; De Girolamo, P.; Besio, G.; Dodd, N.; Zhu, F.; Schimmels, S. (2022). Wave overtopping at near-vertical seawalls: Influence of foreshore evolution during storms. Ocean Eng. 261: 112024. https://dx.doi.org/10.1016/j.oceaneng.2022.112024
In: Ocean Engineering. Pergamon: Elmsford. ISSN 0029-8018; e-ISSN 1873-5258, more
Peer reviewed article  

Available in  Authors 

Keywords
    Coastal protection > Coastal safety against extreme storms > Harbour structures
    Physical modelling
    Structures > Hydraulic structures > Coastal structures
    Wave overtopping
    Marine/Coastal
Author keywords
    Beach foreshore; Seawall; Storm sequences; Coastal flooding

Project Top | Authors 
  • Hydralab+ ICODEP, more

Authors  Top 
  • Briganti, R.
  • Musumeci, R.E.
  • Van der Meer, J.
  • Romano, A.
  • Stancanelli, L.M.
  • Kudella, M.
  • Akbar, R.
  • Mukhdiar, R.
  • Altomare, C., more
  • Suzuki, T., more
  • De Girolamo, P.
  • Besio, G.
  • Dodd, N.
  • Zhu, F.
  • Schimmels, S.

Abstract
    This work presents the results of an investigation on how wave overtopping at a near-vertical seawall at the back of a sandy foreshore is influenced by sequences of erosive storms. The experiments were carried out in the Large Wave Flume (GWK) at Leibniz University, Hannover (Germany). The tested layout consisted of a near-vertical 10/1 seawall and a sandy foreshore with an initial 1/15 slope. Three sequences of idealised erosive storms were simulated. Within each storm both the incident wave conditions and still water level were varied in time to represent high and low tide conditions. Each sequence started from a 1/15 configuration and the beach was not restored in between storms. The measurements included waves, beach profile, wave overtopping volumes. The profile of the beach was measured after each sea state tested.
    Wave overtopping at each stage of the tested storms was significantly influenced by bed changes. This was linked to the measured evolution of the beach. Measurements showed that a barred profile developed quickly at the start of each sequence, and scour developed at the toe of the structure during high water level conditions, while accretion or partial backfilling developed during low water level conditions. Due to these processes, the position of a sea state in the tested sequence is shown to be an important factor in determining the wave overtopping volume. Remarkably, when a weaker idealised storm followed a more energetic one, nearly the same level of overtopping was recorded. This is explained by the foreshore erosion, leading to increased water depths and wave heights at the toe of the structure. This finding allows to quantify and to explain the variability of wave overtopping in storms following one another at intervals shorter than the recovery time of the foreshore.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors